Increasing acceleration speed and vertical jump ability in athletes: what we train, why it works, and how we measure it.
By Alistair TaitHead Coach, Power2ADAPTAustralian Athletics Level 4 High Performance CoachBachelor of Sports Coaching (PE Stream)
Start
0.00
5 m
1.02
10 m
1.69
20 m
2.85
Average splits (seconds) for national open-age male footballers, AIS data. See where you sit in the benchmarks below.
Why speed
In most sports, nothing beats speed
The faster athlete gets there first. Speed creates space, buys time, and gives you more options when the decision matters, especially in team sports.
To move fast, you have to train fast.
Speed is a deciding factor in a huge range of sports, and it's the quality coaches and athletes most want to improve. In team sports, most sprints are short. The first few steps usually decide the contest, which is why this program is built around two simple tests: the 20 m sprint, which measures how quickly you accelerate, and the vertical jump, which measures how much power your legs can produce.
Team-sport coaches call acceleration "speed off the mark". It's different from reaction time, which is how quickly you respond to a signal. Reaction gets you moving; acceleration decides how quickly you reach full speed once you are.
The physics
Speed is force, applied fast
To accelerate, you have to change your velocity, and the only way to do that is to push against the ground. Newton's second law sets the rules:
Force = mass × acceleration
Note that it's mass, not weight. A heavier athlete has to produce more force to accelerate at the same rate, horizontally in a sprint or vertically in a jump. That's why we train both strength and the speed at which you can apply it.
Once you're moving, your running speed comes down to two things:
Speed = step length × step frequency
Take a 10.0 s 100 m sprinter with an average step length of 2.0 m. That's 50 steps, so each step has to take 0.20 s, or 5 steps per second. Every one of those 0.20 s is split between time on the ground and time in the air.
To get faster, you want to lengthen the step while holding or lifting the frequency. The two trade off against each other: overstride and your frequency drops, chop your steps and you lose length. The coaching job is finding the best combination for each athlete. Try it below.
Steps
50
Time per step
0.20 s
Frequency
5.0 Hz
Real races are messierStep length grows through the race, from short, powerful steps out of the blocks to the longest steps at top speed. Most elite men cover 100 m in roughly 44 to 48 steps. Biomechanists also count a stride as two steps, so we use "step" here to keep the numbers clean.
Ground contact at top speedAbout 0.08 s for an elite sprinter, and closer to 0.12 s for a typical team-sport athlete. Less time on the ground, with the same or more force, means more speed.
The tools
Three ways we build speed and power
Each one targets a different part of the same goal: produce more force, and produce it faster.
Acceleration
Repeat 20 m sprints
What it trains
Your ability to produce big horizontal forces in the first steps, so you hit higher speeds sooner.
Why 20 m
Most team-sport athletes are still accelerating at 20 m (top speed usually arrives around 30–40 m), so every rep is pure acceleration work.
Energy system
The phosphagen (ATP-PC) system, which dominates short, all-out efforts of up to about 6–10 s. Full recovery between reps keeps every rep fast and trains the nervous system to recruit more fast-twitch fibres.
Power
Jump squats
What it trains
Leg power: how much force you can produce, and how quickly.
Why it works
Explosive jumps teach the nervous system to recruit more muscle fibres at once and raise your rate of force development. Underlying strength training lifts the ceiling on how much force there is to express.
Reactive strength
Plyometrics
The name
From the Greek pleíōn, "more", and metric, "to measure".
What it trains
Your capacity to absorb force on landing and redirect it straight back into the ground, using the stretch-shortening cycle of the muscle and tendon.
The goal
Repeated hops and bounds train the body to spend less time on the ground while still producing high forces.
In athletics: never more than two weeks from top speed
In athletics, speed and power decide results. Sprinters need to drive out of the blocks and reach top speed quickly. Hurdlers need to push off the ground at speed to clear each barrier efficiently, then hold that speed between the hurdles.
That's why athletes train speed all year round. Many Olympic-level coaches work to the rule that an athlete should never be more than two weeks away from their peak speed. Getting there means training speed and power regularly, so the nervous system keeps its ability to recruit the maximum number of muscle fibres, and progressing the load over time.
Benchmarks
Measure first. Then measure again.
The only way to know a program is working is to measure a starting point. We test at three moments:
Before
Baseline
Where you are now, and how well you move for your sport.
During
Check-in
Are you coping with the workload and adapting? Do we need to adjust? Results can also flag problems with nutrition, hydration, sleep or recovery.
After
Result
The percentage improvement you've earned by following the program.
We all want to know that the time and effort paid off.
Interactive
Rate your vertical jump
Choose the comparison group, enter your best jump, and see where it sits.
Rating
Above average
Got your number? Post your jump in the Power2ADAPT Speed School community and see how you stack up.
Ratings via Mackenzie (2007), Sargent Jump Test, brianmac.co.uk. Normative tables describe groups. They can't account for maturation, so young athletes should be judged mainly against their own previous results.
Elite benchmarks
How Australia's best compare
20 m sprint splits and vertical jump for AIS, national, state and academy athletes. Mean ± standard deviation.
20 m sprint, seconds
Sport
Sex
Level
Age
5 m
10 m
20 m
Vertical jump, centimetres
Sport
Sex
Level
Age / position
Jump (cm)
Source: Tanner & Gore (eds), Physiological Tests for Elite Athletes, 2nd ed., Australian Institute of Sport, Tables 14.2 and 14.3. Cricket sprints start 50 cm behind the 0 m line.
Try it
Now you know where you sit. Here's how to train it.
This is the first session of Coach Al's 4-week Acceleration Development program, in full. Do it this week.
Week 1 · Session 1
Benchmark day
Speed · Agility · Plyo
Warm-up
1 easy lap, then over 20 m: skips, side skips, backpedal into skip, pogos (20 on the spot, 10 side to side, 10 forward and back). ▶︎ Skips▶︎ Pogos Drills ×2 each: A-skip, butt kicks, scissors, high knees.About 10 minutes
Walk back
Run-throughs
4 × 50 m at 60%, 70%, 80%, 90%
Walk back
Start primer
4 × 10 kneeling split-stance starts ▶︎ WatchPush off and drive the arms
Expect quick improvement early, especially if you're new to structured training. Most of those first gains come from your nervous system: better coordination and better use of the muscle you already have.
At a few points during the program, particularly in longer blocks, your results may stall or dip slightly for 3 to 5 days. That's fatigue from the progressive overload catching up with you. Once you recover, the adaptation shows up and your performance climbs to a new level. This rebound is called supercompensation. Complete the program and your 20 m and vertical jump will improve.
The classic supercompensation model. Time the next session during the peak and the gains stack up; wait too long and they fade. It's a simplification, since fitness and fatigue build in parallel, but it explains why rest is part of the program.
What affects results
Five things that move the numbers
Preparation
A proper warm-up raises muscle temperature and rehearses the movements you're about to perform, for the body and the mind. Keep it dynamic before speed work and save long static stretches for afterwards, because they can blunt sprint and jump performance.
Turn up fuelled and hydrated so your muscles can work at their best. Sleep and nutrition do most of the recovery work. Massage, physio and contrast showers can help you feel fresher and loosen up between sessions.
Injury & rehab
Previous injuries, current limitations or an active return-to-play program can all affect your results. Recovery time differs for every athlete, so tell your coach about any injury or limitation at the start and throughout the program. A modified program can still be highly successful.
Maturation
Biological age (how physically mature you are) and training age (how long you've trained) both have big effects on results. The fastest growth, called peak height velocity, happens around 12 for girls and 14 for boys on average, but individuals can be years either side. Strength and speed often improve quickly through and after puberty, especially in boys, and coordination can dip temporarily during a growth spurt.
Normative tables don't account for the late developer, who may keep growing and maturing well past the school years.
Boys' growth rate by maturity group: same pattern, different timing. Illustrative curves drawn after Sherar et al. (2005).
Total load
Are you doing other training at the same time? A well-designed program accounts for everything you do, including training and games in other sports. For example, a lighter session is planned if you've played a hard, physical game of soccer in the previous day or two.
Environment
Results are affected by conditions, so we repeat each test the same way every time:
Same place and surface. Indoors removes wind, which can add or take away several hundredths over 20 m.
Same timing method and start. Electronic timing gates and a stopwatch aren't interchangeable, and a standing start differs from a rolling one.
Same time of day. Sprint and jump performance usually peaks in the late afternoon and early evening, when body temperature is highest.
Weather and altitude. Heat and cold affect energy and mood. Thinner air at altitude slightly helps short sprints and jumps but hurts endurance.
Good footwear for grip on the testing surface.
Your program
Built for the athlete in front of us
Every personalised program starts with how you move. We use a movement screen and range-of-motion tests to find tight muscles, postural imbalances and your individual build (height, limb lengths and so on). Then we watch how you run, jump and change direction.
From there, one principle guides the design: SAID, Specific Adaptations to Imposed Demands. It's one of the most important ideas in sport science, and it means you get what you train for. Your body adapts to, and gets better at, exactly what you practise. So the program has to match your sport in four ways:
Movements
Training must transfer to the sport: running faster, jumping higher, tackling harder, changing direction more sharply.
Energy systems
A 100 m sprinter trains mainly the ATP-PC system. A 200–400 m runner adds the anaerobic glycolytic system. AFL players need all three systems, plus the ability to recover between and repeat efforts.
Motor skills
Learning new movement skills physically changes the brain. Good programs build skill, not just fitness.
Injury resilience
Every athlete should be "bulletproofed": joint stability, proprioception, trunk control and muscle mass, depending on the sport and the athlete.
What we consider for every athlete
Current condition
Bodyweight, training age, biological age and current fitness all shape training and test results. A heavier athlete has to produce more force to accelerate their mass horizontally and vertically.
Goals
Get faster and more powerful. Build muscle. Make a state or national team. Repeat sprints better and recover faster. Lift heavier. Produce more force.
Time frame
How often do you compete, how many games a week or month, and how many days can you give to speed and power training? A speed and power program typically needs a 12-week commitment:
Weeks 1–4
Learn
Body and brain learn the new training demands.
Weeks 5–8
Consolidate
Become competent and consistent.
Weeks 9–12
Perform
The improvement and new performance level come through.
Outside load
What does your sport demand? Is there body contact? What are its aerobic, power and strength demands?
Progressions
Add weight training to build useful muscle mass that produces more force. Once a foundation of strength is in place, progress to more complex plyometrics: box jumps, weighted jumps and hops, and finally drop jumps.
Training rules
Quality over quantity
Maximal sprints and plyometrics are high intensity. They load the nervous system, muscles and tendons hard, so recovery between efforts and between sessions is part of the training.
80–100Ground contacts per session
The ceiling for a beginner's plyometric session. Every jump and hop counts.
2–3 minRest between sets
Enough to come back fully. If reps slow down, the session has done its job.
48 hBetween speed & plyo sessions
Never on consecutive days. Allow at least 48 hours between high-intensity sessions.
On the track
Coach Al's acceleration cues
Push the ground away
Punch the back leg through
Push back, not down
Big arms. Quick, powerful steps
Build up to top speed
Start with intent. Aggressive arms.
The payoff
More force. Less time. Faster.
Repeat sprints teach you to accelerate. Jump squats build power. Plyometrics teach you to use the ground quickly. Test, train, recover and test again, and the 20 m and vertical jump numbers will follow.
Get tested
Where do you sit?
Book a 20 m sprint and vertical jump assessment on the Mornington Peninsula, then get a program built around your results.